Planet BSP-115PV-15A solar PoE+ switch 5x1Gb 1x1Gb SFP 5x PoE+ 802.3at -20~65°C IP30 LCD display

PLANET BSP-115PV-15A

Solar powered PoE+ switch with integrated MPPT controller offers 5x RJ-45 10/100/1000 Base-T with PoE+ IEEE 802.3af/at (35 W/port), 120 W PoE budget, DIP switch and 1× SFP 100/1000 Base-X. LCD display for power information.

1× 6pin terminal block (removable), pins 1/2, 3/4 for PV (photovoltaic) panels + some types of generators (water or wind), pins 5/6 for battery charging/discharging. The PV input is compatible with the DC input, but must not be connected at the same time as the solar input to avoid damage to the device. There is a DIP switch on the front to configure PoE and VLAN. The DIP switch on the back is then used to set battery type and voltage. ESD protection up to 4 kV (contact), up to 8 kV (air), temperature sensor (detection -20 to 100 °C), protection IP30 (metal housing), without fans (fanless), mounting on the wall or on table, operating temperature -20 to +65 °C.

A solar PoE switch that supports the simultaneous use of solar (PV) and battery power. The energy obtained from the solar panel is stored in a battery with a voltage of 12 or 24 V. Then, when solar power is not available, the battery is used to power the switch and connected devices.

This solution provides the possibility to power connected active devices, such as IP cameras, switches, converters or Wi-Fi units, all the time and without dependence on the power network. The application is therefore suitable for ensuring supervision in the environment of parks, forests, cottages or large agricultural and industrial areas. Thanks to the uninterrupted power supply, it can also be used as a means of building telecommunications points for local Internet providers.

Management of accumulators/batteries

• Supports lithium (Lithium, Li-Fe) and lead-acid (Lead-acid, Pb) batteries, optional
• Input power (PV IN): min. voltage 20-27 V DC (12 V battery), 32-45 V DC (24 V battery), max. current 15 A, power up to 405 W (for 12 V battery, 675 W for 24 V battery)
• Easy diagnosis of the operating status of the system using the LED indicator
• Current battery usage status
• MPPT (Maximum Power Point Tracking) charge controller
• Reverse current protection (prevents the reverse flow of electric current into the photovoltaic panel)
• Overcurrent protection and reverse polarity protection (for battery and charging electrodes)

Physical properties

Ports

• 5x RJ-45 10/100/1000 Base-T with PoE+ IEEE 802.3af/at
• 1× SFP Base-X

Memory

• 2K MAC addresses
• 2.5 Mb buffer

Throughput

• 12 Gbps bus
• operational 8.92 Mpps (64B)

Execution

• desktop
• on the wall

Power supply (switches)

• via photovoltaic panels (DC 20-45 V) or from the battery (DC 12/24 V)
• total power consumption up to 140 W (full load with PoE power supply)

Power requirements

• Solar panel: 20-27 V DC (12V battery), 32-45 V DC (24V battery)
• Batteries: 12/24 V, lithium (Lithium, Li-Fe) and lead batteries (Lead-acid, Pb) Output power: 5x PoE+ RJ-45, 6pin terminal block (2x input for PV panel, 1x power input/output for 12/24V battery)

Protection

• ESD up to 4 kV contact
• 8 kV by air (ethernet)

Operating temperature: -20 to +65 °C

Dimensions: 197 x 142 x 34 mm

Weight: 820 g

PoE function

Total power output

• up to 120 W
• 802.3af/at

Number of injectors: 5× to 35 W

Power type: End-span

Advanced features

• protection (circuit) against interference between ports
• automatic detection of powered equipment
• detection of the activity of powered devices, if there is no response, it can be restarted by disconnecting the power supply (PD alive check)
• Extended mode 10 Mb/s with a range of up to 250 m

Switch has a manual mode switch

• Alive check - monitors the status of connected devices in real time, as soon as the device becomes unresponsive, restoring the power will bring it back into operation.
• VLAN - ports are logically separated from each other, in this mode unwanted multicast and broadcast storms can be avoided.
• Extend - switch powers the device up to 250 m with a reduced throughput of 10 Mb/s per port.