XtendLan POE-PAS Power-over-Ethernet set 100Mb black

XtendLan POE-PAS

Passive Power Over Ethernet kit (splitter + injector) for powering the AP over an Ethernet cable. This is a complete set (injector + splitter). For shorter distances, it is usually possible to use the standard supplied power adapter with a 5.5 x 2.1 mm connector for the AP. The connection corresponds to conventional passive PoE - the center of the power connector is connected to the central wires (blue pair), the shell of the power connector is connected to the outer wires (brown pair).

Power Over Ethernet is a simple way to secure the power supply of the access point on the roof or anywhere where mains voltage is not available. Passive PoE uses the free wires in the Ethernet cable and supplies electrical power to devices on the far side. For short distances (approx. up to 10 m, depending on the specific device), it is usually possible to use this passive PoE. For longer distances, use active PoE according to 802.11af.

Attention! Don't try to compensate for the voltage drop on a long eth line. cable by using a non-standard power supply with a higher voltage rating than recommended for your active device.

Voltage drop on eth. of the cable occurs only if the source is under load and current flows through the cable. At the moment of reduction in current consumption (e.g. when the access point is rebooted), the full voltage of the source reaches the remote end of the line, which in extreme cases can damage the input stabilization circuits of the access point._

Maximum permitted power: 48 W at a maximum voltage of 48V

Ethernet speed: 10/100 Mbps

Power Connector 1: 5.5 x 2.1mm (M)

Power Connector 2: 5.5 x 2.1mm (F)