Victron BlueSolar-LCD&USB 30A PWM solar controller

Victron PWM controller BlueSolar-LCD&USB 30 A

Illustrative photo - There is a 10 A version in the gallery that has different dimensions.

Solar PWM controller (12/24 V, charging current 30 A) with integrated LCD and USB. It is suitable for small panels up to 360 Wp (720 Wp for 24 V). It is designed for small island solar systems. The advantage is very simple and undemanding installation and reliable operation.

• 36 cell solar panel(s) recommended for charging the 12V battery (max. current 30A)
• For charging the 24 V battery, a solar panel/s with 72 cells or two 36 cells connected in series is recommended (max. current 30 A)
• With a 12 V battery, a maximum of panel/s with a power of up to 360 Wp can be connected
• With a 24 V battery, a maximum of panel/s with a power of up to 720 Wp can be connected
• Built-in clear LCD display for status monitoring and parameter settings

Powering DC appliances

Excessive discharge of the accumulator can be prevented by connecting all DC loads to the DC output of the regulator (terminal on the right). The DC output disconnects the load when the battery is discharged to a preset voltage. It automatically reconnects the load as soon as the battery is at least partially charged. Connection and disconnection voltages are adjustable. Do not connect a voltage converter to the DC output - connect it directly to the battery.

Programmable battery charging algorithm

Pre-programmed algorithms for lead-acid AGM, GEL, liquid or LiFePO4 batteries (only batteries with internal BMS).

2x USB outputs 5 V

You can easily use the USB output, for example, to charge your mobile phone, etc. Maximum current 2 A (both outputs combined).

Simple installation

1. Connect the battery - plus and minus.
2. Connect the solar array - plus and minus.
3. Connect the load - plus and minus.

The reverse order applies when uninstalling.

Failure to follow this order may damage the BlueSolar PWM charge controller

A) Make sure the battery is charged before the first installation

B) The cable to the battery should be as short as possible to minimize losses

C) The regulator is only suitable for lead-acid and LiFePO4 batteries

D) The charge controller is only suitable for regulating solar panels. Never connect another charging source to the solar controller

Detailed technical information can be found in the attached technical sheet (datasheet) and instructions.

Battery voltage: 12/24 V (auto detection

Rated charging current: 30 A

Automatic load shedding: yes

Absorption charging: 14.4 / 28.8 V

Floating charging: 13.7 / 27.4 V

Load disconnection: 11.2 / 22.4 V

Load reconnection: 12.6 / 25.2 V

Coverage: IP20

Weight: 0.3 kg

Dimensions: 184 x 101 x 47 mm